You are browsing the archive for Cracked It | drawing.

Homemade writing slope

November 4, 2016 in Solution

1298957

Make your own using 3 easy items.

  • Use a strong A4 binder (this one is a 3D ring 50mm binder)
  • A clipboard
  • A non-slip mat (you can buy this by the roll, however I found my small non-slip mat used for turning jars worked perfectly).

Simply assemble and you are ready to use it!

This is definitely an economical way to make a slope board and is perfect for those wanting to try out a slope board before paying for a longer term item. This homemade version cost me less than $15.

Via Your Kids OT

8415729

Remember to click the ‘This Solution Helped Me’ button at the top of the page, and post a picture of your writing slope in the comments!

Pencil topper and page turner

September 28, 2016 in Solution

IMG_20151101_221940_preview_featured

Via Thingiverse

A nifty pencil topper that lifts your pencil off the table so it can easily be picked up. Download the design files and give this fix a try!

Download the design files

Our sponsor charity DEMAND Design & Manufacture for Disability will be happy to help if you don’t have access to a 3D printer, just get in touch via their website.

Remember to click the ‘This Solution Helped Me’ button at the top of this page, or leave a comment letting us know how you got on with this solution!

Via Thingiverse

3D printed Pencil grip

September 28, 2016 in Solution

bubble_grip_detail_preview_featured

Via Thingiverse

A funky pencil holder to improve grip, why not make this and give it a go!

Download the design files

Our sponsor charity DEMAND Design & Manufacture for Disability will be happy to help if you don’t have access to a 3D printer, just get in touch via their website.

Remember to click the ‘This Solution Helped Me’ button at the top of this page, or leave a comment letting us know how you got on!

Via Thingiverse

Pen lid remover

September 28, 2016 in Solution

2012-11-13_19.59.17_preview_featured

Via Thingiverse

This nifty 3D printed device is designed to make it easier to remove caps from pens, why not make it and test it out!

Download the design files

Our sponsor charity DEMAND Design & Manufacture for Disability will be happy to help if you don’t have access to a 3D printer, just get in touch via their website.

Remember to click the ‘This Solution Helped Me’ button at the top of this page, or leave a comment letting us know how you got on!

Via Thingiverse

Skip to toolbar